What should you notice when using your lifting point?
 |
When using swivel lifting point, do not exceed its rated load.
Tap holes in the workpiece so that the lifting points are mounted perpendicular to the workpiece surface.
The surface of the workpiece must be flat, so that the ring washer is in full contact with the surface of the workpiece, and there must be no gap in the middle.
When the swivel lifting point is rotated, the lifting ring bolt may gradually loosen, and the torque must be re-specified and tightened again.
Swivel lifting points must use matching special bolts and nuts.
Lifting points are not suitable for high-speed rotation at full load
